Affiliation:
1. Technical University of Kosice
2. Technical University of Košice
Abstract
The paper presents the results of the research aimed at quality determination of cladding layers for renovation of the rollers during continuous casting of steel. Four newly designed additive materials in the form of filled tubular wires of diameter 2.4 mm were evaluated. Additive materials were experimentally designed for the renovation of support rollers of the hot rolling mill. The cladding layers were applied on 31CrMoV9 material (EN 10085). Method used in experimed was submarged cladding 121 - EN ISO 4063 SAW. A specially developed flux WLDC 17 was used. The structure of cladding layers, basic mechanical propertis and their chemical composition were determined. The JOEL JSM-7000F electron microscope was used for analysis. Layers were tested under tribological conditions with pin-on-disc adhesion wear. Tests were performed on a Bruker UMT 3 device. Observation and measurement of wear traces were performed on the Sensofar PLu Neox confocal microscope.
Publisher
Trans Tech Publications, Ltd.
Subject
Condensed Matter Physics,General Materials Science,Radiation
Reference18 articles.
1. J. Brezinová, et al., Effect of working temperatures on properties of continuous steel casting rolls cladding layers, Chem. Listy 106, S3 (2012) 387-389.
2. J. Viňáš, et al., Evaluation of the quality of cladding deposited on continuous steel casting rolls, Int. J. Mater. Res. 104, 2 (2013) 183-191.
3. J. Brezinová, J, Viňáš, P. Maruschak, A. Guzanová, D. Draganovská, M. Vrabeľ, Sustainable Renovation within Metallurgical Production, 1st ed.; RAM–Verlag: Lüdenscheid, Germany, (2017).
4. J. Viňáš, J. Brezinová, A, Guzanová, Analysis of the quality renovated continuous steel casting roller, Sadhana-Acad. Proc. Eng. Sci. 38 (2013) 477-490.
5. P. Mohyla, K. Foldynová, Influence of Post Weld Heat Treatment on Mechanical Properties of P92 Welds Made by Submerged Arc Welding, Met. Sci. Heat. Treat. 56 (2014) 206-209.