Measurement and Analysis of Mass Flow and Feed Speed Impact on Technological Head Vibrations during Cutting Abrasion Resistant Steels with Abrasive Water Jet Technology-Reference-Cited by-同舟云学术

Measurement and Analysis of Mass Flow and Feed Speed Impact on Technological Head Vibrations during Cutting Abrasion Resistant Steels with Abrasive Water Jet Technology

Published:2015-10 Issue: Volume:669 Page:243-250
ISSN:1662-9795
Container-title:Key Engineering Materials
language:
Short-container-title:KEM

Author:

Salokyová Štefánia¹

Affiliation:

1. Technical University of Košice

Abstract

The article presents the results of Technical University in Košice Faculty of Manufacturing Technologies Department of production processes operation and Technical University in Ostrava Physics Institute Liquid jet workplace cooperation in the area of operational states diagnosis of manufacturing systems with abrasive water jet technology (AWJ). Within the operational states diagnostics is the impact of selected technological parameters on technological head vibrations studied. Based on an extensive set of experiments are original graphical dependences determined of the abrasive mass flow and feed speed impact on the vibrations parameter - technological head vibrations acceleration amplitude of manufacturing system with AWJ technology. In addition to the original graphical dependences are in article new knowledge formulated in the area of science and research and recommendations for companies that operates manufacturing systems with AWJ technology.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,General Materials Science

Link

https://www.scientific.net/KEM.669.243.pdf

Reference15 articles.

1. Ľ. Bičejová, Modelling and simulation of operational conditions influencing the formation and extent of vibrations in manufacturing systems, Dissertation, FMT TUKE, Prešov, (2010).

2. P. Jacko, Modelling and simulation of technological parameters related to usage of non-traditional abrasives in AWJ technology, Dissertation, FMT TUKE, Prešov, (2011).

3. Š. Salokyová, Analysis, Modelling and simulation of vibrations in manufacturing systems with water jet technology, Dissertation, FMT TUKE, Prešov, (2012).

4. S. Fabian, Š. Salokyová, P. Jacko, Experimental verification of the frequency spectrum of unwears and wears guidance tube on the technological head vibrations creation in the production system with AWJ technology, Manufacturing Technology 12/13 (2012).

5. S. Fabian, Š. Salokyová, T. Olejár, Analysis and experimental study of the technological head feed rate impact on vibrations and their frequency spectra during material cutting using AWJ technology, Nonconventional Technologies Review 4 (2011).

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Analysis of Several Physical Phenomena Measured on the Metallic Materials Cut by Abrasive Water Jets (AWJ);Materials;2022-10-22

2. Notes on the Abrasive Water Jet (AWJ) Machining;Materials;2021-11-19

3. Abrasive Waterjet (AWJ) Forces—Potential Indicators of Machining Quality;Materials;2021-06-15

4. Abrasive Waterjet (AWJ) Forces—Indicator of Cutting System Malfunction;Materials;2021-03-29

5. Influence of Material Structure on Forces Measured during Abrasive Waterjet (AWJ) Machining;Materials;2020-09-02