Abstract
In this study, the authors employ a multi-point die-support structure to hold the upper die for deep drawings in order to adjust the distribution of the blank holding force (BHF) so as to eliminate wrinkles. The developed multi-point support structure has 12 support cells (support units) between the upper die and the outer slide of a double-action press; the cells are metal cylinders working as springs. The support unit has a ball contact at the interface with the upper die, and the interface freely rotates and slides horizontally. The support unit has strain gauges on the side surface, and the bearing load at each unit can be determined, as well as the elastic deformation. The bearing load distribution is observed through a trial blow, and then the support units are manually relocated to better distribute the supporting points to create the appropriate BHF distribution. To demonstrate the efficiency of the suggested structure, the authors perform deep drawing with off-centered setting of a blank to create wrinkles intentionally. They then employ the multi-point die-support system, relocate the support units, and eliminate wrinkles.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Reference7 articles.
1. F. Gao, T. Matsumoto, K. Mukai, An Experiment Investigation of Effect on Blank Holding Force in Drawing Process, Die and Mould Technology, 27-7(2012), pp.14-15.
2. A. Watanabe, Y. Kotani, S. Nishida, H. Watari, Cylindrical Deep Drawing Process with Segment Blank Holder, Proc. Joint Conf. of Blocks of Kanto Branch of JSME, (2011), 145-146.
3. S. Ujihara, Y. Hirose, Formability of Autobody Panels Using Controlled Blank Holding Force, J. Japan. Soc. Technopl. Plast., 33-375(1992), pp.373-378.
4. T. Yagami, K. Manabe, M. Yang, Development of Sheet-Stamping Simulator for Distributed Blank Holder Force Control -Intelligent Sheet Stamping by Distributed Blank Holder Force Control I-, J. Japan. Soc. Technopl. Plast., 48-553(2007), pp.145-149.
5. T. Yagami, K. Manabe, Intelligent Process Control Algorithm for Segment Blank Holder -Intelligent Sheet Stamping by Distributed Blank Holder Force Control II-, J. Japan. Soc. Technopl. Plast., 48-553(2007), pp.150-155.