Combined Indentation Testing of Spark Plasma Sintered Steels-Reference-Cited by-同舟云学术

Combined Indentation Testing of Spark Plasma Sintered Steels

Published:2015-09 Issue: Volume:662 Page:43-46
ISSN:1662-9795
Container-title:Key Engineering Materials
language:
Short-container-title:KEM

Author:

Musalek Radek¹,Tesar Tomas²,Strasky Josef³,Cech Jaroslav²

Affiliation:

1. Institute of Plasma Physic AS CR

2. Czech Technical University in Prague

3. Charles University in Prague

Abstract

Mechanical properties of two stainless steels (AISI 316L and AISI 410) processed by spark plasma sintering (SPS) were evaluated by four different types of indentation-based tests: hardness mapping, evaluation of indentation stress-strain curves, instrumented indentation and bonded-interface technique. Obtained results showed that the used combination of relatively simple experiments may provide a deeper understanding of mechanical behavior of materials prepared by SPS.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,General Materials Science

Link

https://www.scientific.net/KEM.662.43.pdf

Reference6 articles.

1. D. Tabor, The Hardness of Metals, Oxford University Press, Oxford, (1951).

2. J. Nohava, Characterization of thermal spray coatings by instrumented indentation and scratch testing Part II: Indentation of plasma sprayed coatings, CSM Instruments - Appl. Bull. 30 (2010) 1–4.

3. J. Nohava, R. Mušálek, J. Matějíček, M. Vilémová, A contribution to understanding the results of instrumented indentation on thermal spray coatings - Case study on Al2O3 and stainless steel, Surf. Coatings Technol. 240 (2014) 243–249.

4. W.C. Oliver, G.M. Pharr, Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodology, J. Mater. Res. 19 (2004) 3–20.

5. L. Prchlik, J. Pisacka, S. Sampath, Deformation and strain distribution in plasma sprayed nickel-aluminum coating loaded by a spherical indenter, Mater. Sci. Eng. A. 360 (2003) 264–274.