The Effect of Degassing Pressure Casting Molds on the Quality of Pressure Casting-Reference-Cited by-同舟云学术

The Effect of Degassing Pressure Casting Molds on the Quality of Pressure Casting

Published:2012-01 Issue: Volume:428 Page:43-46
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Gaspar Stefan¹,Maščeník Jozef¹,Pasko Ján¹

Affiliation:

1. Technical University in Košice

Abstract

In these days in foundry branch there is a rapid development of sectors of special casting technology with the aim to increase the quality and the efficiency of pressure casting production.. Internal homogeneity of pressure casting, characterized by the extent of porosity can be affected by the setup of technological parameters of pressure casting and last but not least by vacuuming the molds, that means to exhaust air and gases from the mold cavity. Contribution is specifically aimed on the analyzing the impact of degassing pressure molds on the porosity of pressure casting.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.428.43.pdf

Reference10 articles.

1. J. Malik, Technológia tlakového liatia zliatin hliníka. HF TU Košice, 2008, p.114 (2008).

2. J. Jurko-M. Džupon-A. Panda-M. Gajdoš-I. Pandová, Deformation of Material Under the Machined Surface in the Manufacture of Drilling Holes in Austenitic Stainless Steel. Chemické listy, Vol. 105, (S), pp.600-602, ISSN 0009-2770, (2011).

3. A. Panda- J. Jurko-M. Džupon-I. Pandová, Optimalization of Heat Treatment Bearings rings With Goal to Eliminate Deformation of Material. Chemické listy, Vol. 105, (S), 2011, pp.459-461, ISSN 0009-2770.

4. J. Jurko, A. Panda, M. Gajdoš, Study of changes under the machined surface and accompanying phenomena in the cutting zone during drilling of stainless steels with low carbon content. Metalurgia journal, Vol. 50, 2, pp.113-117, ISSN 0543-5846, (2011).

5. J. Jurko, A. Panda, M. Gajdoš, Accompanying phenomena in the cutting zone machinability during turning of stainless steels. International Journal Machining and Machinability of Materials, INDERSCENCE Publisher, Vol. 5, No. 4, 2009, 383-400 p. ISSN 1748-5711, (2009).

Cited by 24 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Test Tube Manufacturing for Mechanical Tests from Recycled Materials;Advances in Design Engineering IV;2024

2. Reuse of Recycled Metals;Lecture Notes in Mechanical Engineering;2023

3. PLUNGER PRESSING SPEED LIKE THE MAIN FACTOR INFLUENCING OF THE MECHANICAL PROPERTIES OF DIE CASTING;MM Science Journal;2019-12-11

4. COMPARISON OF SELECTED MATERIALS INTENDED FOR THE MANUFACTURE OF PLASTIC HOLDER FOR REVERSE PARKING SENSOR WITH THE USE OF COMPUTER SIMULATION TOOLS;MM Science Journal;2019-12-11

5. INFLUENCE OF DIE CASTING FACTORS AND OF HARDENING TEMPERATURE UPON MECHANICAL PROPERTIES OF A DIE CAST;MM Science Journal;2018-12-12