Effects of Environmental Humidity on the Tribological Properties of Modified PTFE Three-Layer Composites-Reference-Cited by-同舟云学术

Effects of Environmental Humidity on the Tribological Properties of Modified PTFE Three-Layer Composites

Published:2013-01 Issue: Volume:631-632 Page:463-466
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Xie Ting¹,Yang Ting Ting¹,Yang Wen Juan¹,Tian Ming¹

Affiliation:

1. Hefei University of Technology

Abstract

In this paper, the tribological properties of the modified PTFE three-layer composites in different humidities were studied. The wear mechanisms of the modified PTFE three-layer composites with and without PI were also analyzed. The test results showed that in the humidity of 15%-75%, the friction coefficients of the composites increased with the humidity increased. At the humidity of 100%, the friction coefficient reduced significantly. With the increase of humidity, the wear of the composites decreased at first and then increased. The smallest wear appeared when the humidity was 45% or 60% for with or without PI composites respectively. And the results also revealed that PI is helpful to improve the wear stability of the composites in different humidities.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.631-632.463.pdf

Reference10 articles.

1. Y. Kimura, H. Ueda, K. Shimasaki, H. Ito. Effects of humidity on friction and wear of a PTFE-based composite, J. Japan Soc. Lubr. Eng. 31(9) (1986) 643-649.

2. Zhaozhu Zhang, Qunji Xue, Weichang Shen, Weimin Liu. Friction and Wear Properties of PTFE Composites Filled by Metals (in Chinese), Polym. Mater. Sci. Eng. 15(1) (1999) 68-72.

3. Gang Chen, Ming-hua Jiao, Ting Xie, Jian-wei Yu. Effects of Fillers on the Tribological Properties of Polytetrafluoroethylene Based Composites (in Chinese), Bearing (10) (2007) 42-45.

4. S. Bahadur, D. Tabor. The wear of filled polytetranuoroethylene, Wear 98 (1984) 1-13.

5. J. Brandrup, E.H. Immergut, E.A. Grulke. Polymer Handbook, NewYork Wiley-Interscience, (1999).