The Integration of CAPP and Production Planning for Bent Sheet Metal Parts-Reference-Cited by-同舟云学术

The Integration of CAPP and Production Planning for Bent Sheet Metal Parts

Published:2005-05 Issue: Volume:6-8 Page:263-270
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Cattrysse Dirk¹,Collin P.,Duflou Joost R.¹,Nguyen T.H.M.¹,Van Oudheusden Dirk¹

Affiliation:

1. Katholieke Universiteit Leuven

Abstract

Both the topics of Computer Aided Process Planning and Production Planning in the context of sheet metal air bending have been presented as standalone topics previously. This paper will focus on the interaction between both modules. Choices made by the CAPP-module seem to influence the possible gains that can be obtained in production planning and vice versa. The used procedures for both the CAPP module, including process planning and tool selection for air bending, and the Production Planning module, modelling the production planning as a Travelling Purchaser Problem, are described. The different areas of interaction between both modules are also specified. Results demonstrate that the interaction between both modules has a significant impact and should be taken into account in an integrated process and production planning system.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.6-8.263.pdf

Reference17 articles.

1. J. Duflou, T.H.M. Nguyen and J. -P. Kruth: Intelligent Tool Preselection - A Contribution To Automatic Process Planning For Sheet Metal Bending, Proc. of 4 th Int. Symp. on Tools and Methods for Competitive Engineering, Lausanne (2004).

2. J. Duflou, T.H.M. Nguyen and J. -P. Kruth: Geometric Reasoning for Tool Selection in Sheet Metal Bending Operations, Proc. of 5th Int. Conf. on Integ. Design and Manuf. in Mech. Eng., Bath (2004).

3. T.H.M. Nguyen, J.R. Duflou, J. -P. Kruth and D. Cattrysse: Tool Optimization for Sheet Metal Bending Operations, 4 th CIRP Int. Sem. on Intel. Comp. in Manuf. Eng., Sorrento (2004), CUES Fisciano Salerno, pp.257-262.

4. T.H.M. Nguyen, J.R. Duflou and J. -P. Kruth: A Framework Design for Automatic Tool Selection in Integrated CAPP Software for Sheet Metal Bending, Proc. of 11th Int. Conf. on Sheet Metal, Erlangen (2005), under review.

5. E. El-Darzi and G. Mitra: Graph Theoretic Relaxations of Set Covering and Set Partitioning Problems, Eur. J. of Operational Res. Vol. 87/15 (1995), pp.109-121.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Sequence Planning and Tool Selection for Bending Processes of 2.5D Sheet Metals;Advances in Mechanical Engineering;2014-01-01