Study of the Impact of Protective Process Agents with Carbon Nanopowder Additives on Chip Forming Processes-Reference-Cited by-同舟云学术

Study of the Impact of Protective Process Agents with Carbon Nanopowder Additives on Chip Forming Processes

Published:2021-05 Issue: Volume:887 Page:319-324
ISSN:1662-9795
Container-title:Key Engineering Materials
language:
Short-container-title:KEM

Author:

Petrovsky E.A.¹,Bashmur K.A.¹,Tynchenko Vadim S.²

Affiliation:

1. Siberian Federal University

2. Reshetnev Siberian State University of Science and Technology

Abstract

The present study describes the impact of various protective process agents on chip forming processes. The research was conducted on NiCr20TiAl and 34NiCrMoV14-5 nickel-chromium alloys. New lubricant-cooling process agents with carbon nanopowder additives are studied. The optimal composition of the nanopowder additive and its effect during alloy cutting is examined. Experiments reveal the dependence of shrinkage ratio on cutting speed and various protective process agents. The values of H50 microhardness are also defined when cutting these alloys using protective process agents. Experimental studies found the positive effect of developed agents with nanopowder additives on the processes of NiCr20TiAl and 34NiCrMoV14-5 alloys chip formation.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,General Materials Science

Link

https://www.scientific.net/KEM.887.319.pdf

Reference12 articles.

1. W.A. Knight, G. Boothroyd, Fundamentals of Metal Machining and Machine Tools, CRC Press, Boca Raton, FL, (2005).

2. V.P. Astakhov, Tribology of Metal Cutting, Elsevier Ltd., London, (2006).

3. E.A. Petrovsky, et al., Control of Geometric Characteristics of Surface Micro-Relief in Metal Turning Using Nanodiamond Powders, J. Phys.: Conf. Ser., 1515 (2020), 042104.

4. G.I. Granovsky, V.G. Granovsky, Cutting of Metals, Vysshaya shkola, Moscow, (1985).

5. P.P. Kulkarni, et al., An Experimental Investigation of Effect of Cutting Fluids on Chip Formation and Cycle Time in Turning of EN-24 and EN-31 Material, Int. J. Eng. Sci. Res. Tech., 3(11) (2014), 574–582.