600 mm-Wide Strip Casting Using Single Roll Caster Equipped with Scraper

Abstract

The casting of a 600 mm-wide 5182 aluminum alloy strip was attempted using a single-roll caster equipped with a scraper. This caster could cast a strip at speeds ranging from 10 to 40 m/min. These casting speeds are much higher than that of a conventional twin-roll caster. The scraper load suitable for scribing the wide strip was investigated. The strip could be scribed at full width by the scraper. The mechanical properties of the strip were investigated using a tension test and a cup test. The tensile stress was 320 MPa and the elongation was 30%. When deep drawing was conducted, no striped pattern, which occurs via segregation, appeared when both surfaces were facing outside.