The Analysis on the Tribological Properties of CR/EPDM Blends with Chrome-Plated Steel under Dry Sliding-Reference-Cited by-同舟云学术

The Analysis on the Tribological Properties of CR/EPDM Blends with Chrome-Plated Steel under Dry Sliding

Published:2013-09 Issue: Volume:774-776 Page:99-102
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Zhao Lian Hua¹,Wei Xiao Bo¹,Li Xiao Guang¹

Affiliation:

1. Shenyang University of Technology

Abstract

It is based on actual working conditions and parameters of the conveyor belt, to reach the purpose of the optimizing rubber by different rubbers mixing technology. Comparison the five kinds rubber and metal of the friction characteristics in dynamic fit, obtained a performance excellent rubber in the specific operating conditions. Then improve the overall service life of the transportation equipment. It is first prepared the same hardness CR and EPDM and blends that is ratio of 2:8, 5:5and8:2 in this article. The pros and cons of the five rubbers are analyzed by friction and wear properties of the above experimental. The test curve of coefficient friction and wear with time has been done under different load at constant low speed, friction and wear and wear mechanism of five rubbers with chrome-plated steel comparatively analyses to determine CR/EPDM = 8:2 blends has the heat resistance and wear resistance are better than CR and EPDM under dry sliding conditions.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.774-776.99.pdf

Reference9 articles.

1. Zhang Siwei. Principles of rubber wear[M] Beijing: Petroleum Industry Press, 1998, 6. (in Chinese).

2. A.I. Khalf, D.E. El. Nashar, N.A. Maziad. Effect of grafting cellulose acetate and methylmethacrylate as compatibilizer onto EPDM/SBR blends[J]. Materials and Design. 2010, 31: 2592–2598.

3. Shokri A. A, Bakhshandeh G, Farahani TD. An investigation of mechanical and rheological properties of EPDM/PVC blends: influence of anhydride additives, mixing procedure and EPDM form. Iran Polym J 2006; 15: 227–37.

4. Lin huzong, Phantasmagoric flowing science-multiphase hydromechanics. Beijing: the book concern of Qinghua University, Guangzhou: the book concern of Jinan University. (in Chinese).

5. S. Q. He, X. Y. An, X. Liu, F. Y. Yang. Journal of Lanzhou University (Natural Sciences). Vol. 44(2) (2008), p.132 (In Chinese).

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Analyzing the Premature Failure of Rubber Bands in Excavator Track Chains;Journal of Failure Analysis and Prevention;2023-12-13

2. Understanding the occurrence of a wavy wear track on elastomeric materials;Wear;2018-10

3. Tribological behavior of short-cut aramid fiber reinforced SBR elastomers: the effect of fiber orientation;JOURNAL OF MECHANICAL ENGINEERING AND SCIENCES;2018-06-30