Microstructure and Properties of Magnesium Alloy by Equal Channel Angular Processing-Reference-Cited by-同舟云学术

Microstructure and Properties of Magnesium Alloy by Equal Channel Angular Processing

Published:2010-10 Issue: Volume:146-147 Page:814-817
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Guo Xiao Qin¹,Guo Yong Chun²,Zhao Xin³

Affiliation:

1. Zhengzhou Institute of Aeronautical Industry Management

2. Xi'an Technological University

3. Zhengzhou Institute of Aeronautics

Abstract

Mg-6Zn-0.6Zr magnesium alloy (ZK60) was extruded by equal channel angular processing (ECAP) equipment via 2, 4, 6 passes at 400°C. The corresponding microstructure and hardness were examined. The change of the crystal plane in this processing was analyzed by X-ray diffraction. The results show that, ECAP favors recrystallization and refines grains with the increase of pass times. The grains are significantly refined to 10um after 6 passes and the hardness is improved to 79.8HV after 4 passes.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.146-147.814.pdf

Reference7 articles.

1. Mordike B L, Ebert T. Magnesium properties applications potential. Materials Science and Engineering, Vol. 30(2001), p.37.

2. Yim C D, Seok H K, Lee J C，et a1. Semi-solid Processing of Magnesium Alloys. Materials Science Forum, 2003, p.419.

3. JIANG Ju-fu, LUO Shou-jing, ZOU Jing-xiang. Preparation of AZ91D magnesium alloy semi—solid billet by new strain induced meltactivated method. Trans Nonferrous Met Soc China, A, Vol. 16 (2006), pl080.

4. Yaojun Lin, Enrique J. Lavernia. Modeling of oxide breakup during equal channel angular pressing of reactively gas-atomized Al powders. Metallurgical and Materials Transactions A, Vol. 37 (2007), p.3317.

5. S.R. Agnew, P. Mehrotra, T.M. Lillo, G.M. Stoica and P.K. Liaw. Crystallographic texture evolution of three wrought magnesium alloys during equal channel angular extrusion. Materials Science and Engineering, A, Vol. 408 (2005), p.72.