Effect of Variation of Injection Moulding Parameters on Static and Dynamic Material Characteristics of Filled Polymer Materials-Reference-Cited by-同舟云学术

Effect of Variation of Injection Moulding Parameters on Static and Dynamic Material Characteristics of Filled Polymer Materials

Published:2018-05 Issue: Volume:1147 Page:42-47
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Contos Vaclav¹

Affiliation:

1. Witte Automotive

Abstract

A Continuum (filled polymer) is inhomogeneous and anisotropic. The Continuum is used in an injection moulding simulation at first (generally unnewton type of fluid). Then the continuum is solid (after cooling) and it is possible to carry out ordinary structural analysis with it both static and dynamic. The solid continuum has different mechanical properties for each of discrete element. The consequent values of mechanical characteristics (after simulation of load) will generally have different values when influence of injection moulding is taken into account for analyses.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.1147.42.pdf

Reference5 articles.

1. O. A. Babatubde, A. J. David. Observed deviations between classical and novel mathematical models for predicting fiber orientation in injection molded composites. 2011 ECTC proceedings ASME technical conference hosted by ASME district E and University of Arkansas. (2011).

2. W. Jin, J. Xiaoshi. Comparison of recent fiber orientation models in Autodesk Moldflow Insight simulations with measured fiber orientation data. Proceeding of the Polymer Processing Society 26th Annual Meeting, Banff (Canada) PPS-26. (2010).

3. Y. J. Juang, S. Wang, X. Hu, L. J. Lee. Dynamics of Single Polymers in a stagnation flow Induced by Electrokinetics, Phys. Rev. Lett. 93 (2004) 268105.

4. H. Miled, L. Silva, T. Coupek, J. F. Agassant. Injection moulding of fibre reinforced thermoplastics: integration of fibre orientation and mechanical properties computations. 27th World Congress of the Polymer processing Society, Marrakech: Morocco. (2011).

5. A. Sillem. Fundamental Theory and implementation of the Wang-O´Gara-Tucker model for the modeling of fiber orientation in fiber filled injection molded thermoplastics. MSC thesis mechanical engineering, Delft University of Technology, (2010).