Abstract
A new developed TiN-TiB2 ceramic cutting tool material (marked as TBN5) with high comprehensive mechanical properties was fabricated by the in-situ integration synthesis process. The cutting performance of TBN5 tool in continuously turning the austenitic stainless steel 1Cr18Ni9Ti was experimentally investigated; the failure modes and failure mechanisms of the cutting tool TBN5 were analyzed combined with its mechanical properties. Aiming at the materials removal amount, the optimal cutting parameters of TBN5 tool in turning 1Cr18Ni9Ti were firstly obtained by the orthogonal tests; and then with this cutting parameters, the cutting performance of TBN5 compared to the commercial tools LT55 and SG4 was studied. The results showed that the advanced tool TBN5 could get longer tool life than LT55 and SG4; the main failure modes of TBN5 were flank wear, breakage and the flaking of main cutting edge. The scope of its flaking was smaller and diffusion wear was not obvious, which was related to the higher fracture toughness and the higher thermal conductivity of TBN5.
Publisher
Trans Tech Publications, Ltd.
Reference7 articles.
1. X.W. Chong, C.Z. Huang, L. Xu, et al, Study on in-situ preparation and growth mechanism of TiCxN1-x whiskers, Adv. Mater. Res. 197-198 (2011) 617.
2. Q. Shi, H.L. Liu, C.Z. Huang and B. Zou, Study on the in-situ fabricated titanium nitride-based ceramic cutting tool materials reinforced by titanium diboride, Adv. Mater. Res. 500 (2012) 679.
3. F.C. Ma, P. Liu, W. Li, et al, Effect of TiB whiskers orientation on mechanical properties in an in situ TiB/Ti-1100 composite, Mater. Trans. 51 (2010) 1277.
4. M.Y. Koo, J.S. Park, M.K. Park, et al, Effect of aspect ratios of in situ formed TiB whiskers on the mechanical properties of TiBw/Ti-6Al-4V composites, Scripta Mater. 66 (2012) 487.
5. T.J. Wang, The turning of stainless steel, Coal Mine Machinery. 29 (2008) 89 (in Chinese).
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献