Study on Calibration and Test of Automotive Wheel Hub Detection System-Reference-Cited by-同舟云学术

Study on Calibration and Test of Automotive Wheel Hub Detection System

Published:2014-12 Issue: Volume:1061-1062 Page:970-973
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Yang Xiao Dong¹,Men Yu Zhuo¹,Yu Lei¹,Gao Jin Gang¹,Yu Hai Bo²

Affiliation:

1. Changchun Institute of Technology

2. China FAW Co., Ltd.

Abstract

The wheel hub detection system produces error inevitably, thus it is necessary to eliminate or reduce such error so that to enhance the measurement precision. Facing the strict requirements on the precision of devices for wheel hub run-out measurement, properties, rules of emerging and contributing factors of such errors were analyzed and results showed that it was necessary to calibrate the laser ranging tester. The input-output relation was learned from the output of such ranging tester too. For non-linear errors emerged, those little errors caused by non-linear issues in actual applications shall be revised so that to reduce detection errors.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.1061-1062.970.pdf

Reference5 articles.

1. Meng C, Gasch R. Stability and stability degree of a cracked flexible rotor supported on journal bearings. Journal of Vibration and Acoustics, (2000), Vol. (122), P. 120-123.

2. Xu ZhangSui, Liu MeiQuan, Mi Dong Wang etl. Imaging Based on Leakage Magnetic Field of Defect[A]. Proceedings of 6th International Symposium on Test and Measurement, (2005) Vol. 15, P. 3-4.

3. W. Kappes, M. kroning. Non-destructive testing of wheel-set as a contribution to safety of rail traffic. Franhofer institute non-destructure testing. (2001), P. 8-14.

4. X Jian, Steve Dixon, Rachel S. Edwards. Ultrasonic field modeling for arbitrary non-contact transducer source. Third International Conference on Experimental Mechanics and Third Conference of the Asian Committee on Experimental Mechanics. Bellingham, (2005).

5. Qiong Chen, Yuanjun Lv. Design of Paper Cutter Machine Proceedings of 2008 IEEE 9th International Conference on Computer-Aided Industrial Design & Conceptual Design (2009), Vol. (l), P. 35-37.