Affiliation:
1. National Research Tomsk Polytechnic University
Abstract
At present the systems of layer-by-layer laser synthesis of three-dimensional articles are used to advance the introduction of new technologies and to reduce its costs. To produce articles in these systems a powder is applied and sintered layer-by-layer with a laser ray on the basis of a 3D CAD-model. The articles are produced in a particular range of laser action which is experimentally selected for each powder. The utilization of new powders, as well as selection of reasonable technological modes for producing articles of definite quality are vital tasks at present [1, 2].
Publisher
Trans Tech Publications, Ltd.
Reference7 articles.
1. V. Kuznetsov, Systems of rapid manufacturing of prototypes and their widening, CAD/CAM/CAE Observer. 4 (2003) 2-7.
2. A. N. Chatterjee, S. Kumar, P. Saha, P. K. Misha, An experimental design approach to selective laser sintering of low carbon steel, Journal of Materials Processing Technology. 136 (2003) 151-157.
3. V. Ya. Panchenko, Laser technologies of machining: contemporary problems of fundamental research and applied designs, monograph, М.: Phismatlit, 2009. [in Russian].
4. А. А. Saprykin, S.I. Petrushin, N.A. Saprykina, Russian Federation, Patent 2268493 (2006).
5. A. A. Saprykin, N. A. Saprykina, Engineering Support for Improving Quality of Layer-by-layer Laser Sintering, 7th International Forum on Strategic Technology IFOST – 2012, Tomsk, 2012. 507-510.
Cited by
10 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献