Development of Combined Machining Modes, Investigation of Mechanical Properties and Structure of Deformed Semi-Finished Products from Alloy 01417

Abstract

The article presents the results of studies on the production of wire with a diameter of 0.5 mm from aluminum alloy 01417 with a content of rare-earth metals (REM) in the amount of 7-9% for aircraft construction needs. The deformation modes, the experimental technique and equipment for the implementation of the proposed technology described. The wire was obtained by drawing and bar rolling with subsequent drawing from a rod with a diameter of 5 mm, obtained previously using the process of combined rolling-extruding (CRE) from a continuous ingot with a diameter of 12 mm, cast in an electromagnetic mold (EMM). The wire obtained by the presented technology was subjected to 4 different heat treatment modes with annealing temperatures from 350 to 500 °C and holding time of 1 h in the furnace to achieve mechanical and electrophysical properties corresponding to TS 1-809-1038-2018. The level of strength and plastic properties obtained in the course of research required only one intermediate annealing. The microstructure of the wire was investigated and the modes were revealed that made it possible to obtain the required level of mechanical properties and electrical resistivity, satisfying TS 1-809-1038-2018.