Affiliation:
1. University of Wasit
2. Universiti Tun Hussein Onn Malaysia
3. University Tun Hussein Onn Malaysia
Abstract
Produced Profiles by direct recycling of aluminum chips in hot extrusion process were achieved by temperature related parameters using preheating temperature 450 °C, 500 °C, and 550 °C for duration 1 hour, 2 hours, and 3 hours preheating time. By using Design of Experiments (DOE) procedure with full factorial design and three center points analysis, the results showed that the preheating temperature factor is more important to be controlled rather than the preheating duration and increase of temperature conducted to the high tensile strength. The profiles extruded at 550 °C and 3 hours’ duration had obtained the optimum condition to get the maximum tensile strength. The influence of parameters of hot extrusion process on fracture surfaces of the recycled samples was also investigated and discussed.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference15 articles.
1. Muhammad Irfan Ab Kadir, Mohammad Sukri Mustapa, Nurul Liyana Rosli, Mohd Shahir Yahya, Mahmod Abd Hakim Mohamad, Abd Khalil Abd Rahim: International Journal of Integrated Engineering Vol. 10 (2018), pp.53-56.
2. Fogagnolo JB, E. M. Ruiz-Navas, M. A. Simon: Journal of Materials Processing Technology Vol.792-5 (2003), p.pp.143-144.
3. A. Sahib M. Altaei, and M. S. Mustapa: Int. J. Mech. Ind. Technol. Vol. 3 (2016), p.98–104.
4. M. H. Rady, M S. Mustapa, S. Shamsudin, M.A. Lajis, A. Wagiman, F. Yusof, M. A. Harimon, M. R. Ibrahim and M. S. Msebawi: Material Science and Engineering Technology, Vol. 50(6) (2019):718-723.
5. Gronostajski J, Chmura W, Gronostajski Z: J Mater Process Technol. 125–126 (2002), pp.483-490.
Cited by
4 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献