Scratch Behaviour of Silicon Solid Solution Strengthened Ferritic Compacted Graphite Iron (CGI)-Reference-Cited by-同舟云学术

Scratch Behaviour of Silicon Solid Solution Strengthened Ferritic Compacted Graphite Iron (CGI)

Published:2018-06 Issue: Volume:925 Page:318-325
ISSN:1662-9752
Container-title:Materials Science Forum
language:
Short-container-title:MSF

Author:

Ghasemi Rohollah¹,Jarfors Anders E.W.¹

Affiliation:

1. Jönköping University

Abstract

The present study focuses on scratch behaviour of a conventional pearlitic and a number of solid solution strengthened ferritic Compacted Graphite Iron (CGI) alloys. This was done by employing a single-pass microscratch test using a sphero-conical diamond indenter under different constant normal loads conditions. Matrix solution hardening was made by alloying with different content of Si alloy; (3.66, 4.09 and 4.59 wt%. Si) which are named as low-Si, medium-Si and high-Si ferritic CGI alloys, respectively. A good correlation between the tensile and scratch test results was observed explaining the influence of CGI’s matrix characteristics on scratch behaviour both for pearlitic and fully ferritic solution strengthened ones. Both the scratch depth and scratch width showed strong tendency to increase with increasing the normal load, however the pearlitic one showed more profound deformation compared to the solution strengthened CGI alloys. Among the investigated alloys, the maximum and minimum scratch resistance was observed for high-Si ferritic CGI and pearlitic alloys, respectively. It was confirmed by the scratched surfaces analysed using Scanning Electron Microscopy (SEM) as well. In addition, the indenter’s depth of penetration value (scratch depth) was found as a suitable measure to ascertain the scratch resistance of CGI alloys.Keywords: Silicon solution strengthening, CGI, Abrasion, Scratch testing, Scratch resistance

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

https://www.scientific.net/MSF.925.318.pdf

Reference23 articles.

1. S. Dawson, F. Indra, Compacted graphite iron-A new material for highly stressed cylinder blocks and cylinder heads, Fortschritt-Berichte VDI, 639 (2007) 181.

2. S. Dawson, I. Hollinger, M. Robbins, J. Daeth, U. Reuter, H. Schulz, The Effect of Metallurgical Variables On the Machinability of Compacted Graphite Iron, SAE Transaction, 110 (2001) 334-352.

3. A. Berglund, C.M. Nicolescu, H. Svensson, The effect of interlamellar distance in pearlite on CGI machining, in: International Conference on Mechanical Engineering, 2009, pp.33-44.

4. G. Grenmyr, A. Berglund, J. Kaminski, C.M. Nicolescu, Investigation of tool wear mechanisms in CGI machining, IJIDEM, 4 (2011) 3-18.

5. H.C. Shin, High-Silicon Ferritic Compacted Graphite Cast Iron Having High-Temperature Strength and High Oxidation-Resistance, in, Google Patents, (2007).