Process Development: Burr and Film Formation during High Speed Punching of Extruded PC Based Polymers

Abstract

First investigations focus on the usage, processing and material properties of polycarbonate (PC) based materials used in cable duct production. Test coupons were taken from in-situ cable ducts including further additives generally used in industry. Different mechanical and optical analytical methods were performed. Significant differences in tensile properties of polycarbonate/ acrylonitrile butadiene styrene (PC/ABS) compared to mineral reinforced PC were observed. The hardness of mineral reinforced PC is significantly dependent on the geometry of the cable ducts. The fracture behavior and morphology of the PC/ABS fracture surface is directly related to the coupon temperature during Charpy impact testing. The process temperature influences the failure behavior during high impact processing such as high speed punching. Due to the lower impact strength of mineral reinforced PC less film and burr formation compared to PC/ABS are likely. However, the mineral distribution is not homogeneous and therefore subject to further investigation. This study aims at a better understanding of process properties of PC/ABS products, parameter selection, quality improvement and general understanding of underlying microstructural and surface properties.