Affiliation:
1. Shanghai Jiao Tong University
Abstract
In this paper, effects of milling parameters on cutting force and surface roughness during symmetrical face dry milling process of super high strength steel 30CrMnSiNi2A were presented. Multiple linear regression model and orthogonal rotary quadratic regression model were established to analyze cutting force and surface roughness, respectively. Their adequacy was estimated by variance analysis and experimental data comparison. Parameters optimization for maximum metal removal rate and minimum surface roughness were also discussed.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference8 articles.
1. Y.Q. Zhou and Z.M. Zhang: 7th International Symposium On Test and Measurement Vol. 1-7 (2007), p.6339.
2. Y. Gao, F. Lu and M. Yao: Surf. Eng. Vol. 21 (2005), p.325.
3. Y. Sahin and R. Motorcu: Mater. Des. Vol. 26 (2005), p.321.
4. H.Z. Zhang, W.W. Ming and Q.L. An: J. Shanghai Jiao Tong Univ. Vol. 44 (2010), p.447.
5. Q.L. Niu, Q.L. An and M. Chen: Key Eng. Vol. 443 (2010), p.256.
Cited by
3 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献