Affiliation:
1. Bialystok Technical University
Abstract
The problem of software creation for the analysis of transient temperature field in cold rolling of metals is under consideration. Firstly, the mathematical model of the process of heating the strip and rolls at cold rolling it is proposed. This model assumes that the generation of heat during the rolling takes place due to friction on the contact surface of the rolls and the strip as well as plastic deformation of the strip material. Next, some fragments of created application for the purpose of an overall numerical analysis of heat partition ratio between the rolls and a strip as well as the temperature in any point of these elements are presented.
Publisher
Trans Tech Publications, Ltd.
Subject
Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics
Reference11 articles.
1. B. Avitzur, Metal Forming: Processes and Analysis, McGraw-Hill, New York, (1968).
2. S. Turczyn , The effect of the roll-gap shape factor on internal defects in rolling, J. Materials Proc. Technol., 60 (1996) 275–282.
3. D.F. Chang, Thermal stresses in work rolls during the rolling of metal strip, J. Materials Proc. Technol., 94 (1999) 45–51.
4. S. Turczyn , Thermal aspects during the cold-rolling of sheets and strips in continuous mills, Institute of Metals, London, (1986).
5. A.A. Tseng, Thermal modeling of roll and strip interface in rolling processes: part 1 – review, Num. Heat Trans. Part A, 35, N 2 (1999) 115–133.