Technological Problems in Lapping on Flat Surfaces of Ceramic Parts-Reference-Cited by-同舟云学术

Technological Problems in Lapping on Flat Surfaces of Ceramic Parts

Published:2013-03 Issue: Volume:199 Page:627-632
ISSN:1662-9779
Container-title:Solid State Phenomena
language:
Short-container-title:SSP

Author:

Barylski Adam¹

Affiliation:

1. Gdansk University of Technology

Abstract

This paper will present the results of research on single-disc lapping of flat surfaces of small ceramic elements. Machining with the use of different tools such as metallic, two-metallic and abrasive-metallic will be analyzed. The basics and techniques of reinforcement of laps will be discussed. The results of the influence of parameters on the surface quality of ceramic conponents (sealing0 for three treatments on lapping machines will be presented on the paper.

Publisher

Trans Tech Publications, Ltd.

Subject

Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics

Link

https://www.scientific.net/SSP.199.627.pdf

Reference13 articles.

1. Th. Ardelt, Verfahrensvergleich Planschleifen mit Planetenkinematik-Planparallelläppen, IDR, 35 (2001) 3, pp.214-224.

2. A. Barylski, Charging of the cast iron lapping tools, Sci. Bull. Rzeszow Univ. Technol., 193 (2002), Mechanics 58, pp.53-56.

3. A. Barylski, M. Deja, Calculation of flatness errors formed on the tool during finishing machining by lapping, Int. J. of Applied Mechanics and Engineering, 7 (2002), special issue SITC 2002, pp.291-296.

4. A. Barylski, Lapping of ceramics using metallic-abrasive lapping tools, in: Proceedings of the 17th Annual Meeting the American Society for Precision Engineering, Scottsdale (2000), pp.110-113.

5. A. Barylski, Lapping of flat surfaces with two-metallic tools, in: Proceedings of The Eighteenth Annual Meeting the American Society for Precision Engineering, Portland (2003), pp.571-574.