Abstract
The article examines the change of the slip-line fields structure with the help of numerical simulation (FEM) in the case of hard turning by gradually decreasing the tool rake angle. During the examination the influencing effect of the stagnation zone on the chip removal was taken into consideration. The stagnation zone is typical of the cutting done by a negative rake angle and it is generally present in front of the tool tip.
Publisher
Trans Tech Publications, Ltd.
Reference37 articles.
1. K. Weinert., D. Biermann, Spanende Fertigung. Vulkan Verlag, Essen, 2008. pp.29-55., 168-187.
2. N. Taniguchi, Current status in, and future trends of ultraprecision machining and ultrafine materials processing. Annals of the CIRP, Vol. 32/2 (1983) pp.573-582.
3. G. M. Maitra, Handbook of gear design. McGraw Hill, New Delhi, 2010, pp.18-24.
4. T. Bausch et al, Innovative Zahnradfertigung. Expert Verlag, Renningen, 2011, pp.1-4., 366-389.
5. S. P. Radzevich, Dudley's handbook of practical gear design and manufacture. CRC Press, Boca Raton, 2012. pp.371-417.