Evaluation of the Performance of Micro-Drills in Drilling a Machinable Ceramic Material-Reference-Cited by-同舟云学术

Evaluation of the Performance of Micro-Drills in Drilling a Machinable Ceramic Material

Published:2014-08 Issue: Volume:619 Page:49-53
ISSN:1662-7482
Container-title:Applied Mechanics and Materials
language:
Short-container-title:AMM

Author:

Shin Hyun Ho¹,Hwang In Joon¹,Lim Sung Jun²,Kim Bum Sup²

Affiliation:

1. Gangneung-Wonju National University

2. Wonik QnC

Abstract

The performance of three different micro-drills in drilling a machinable ceramic material has been evaluated in terms of the critical feed speed (mm/min) at a given rotation rate (rpm). The critical speed is the feed speed from and above which the chipping on the rear side of the machinable ceramic material takes place. The determined critical speed turns out to increase with rotation rate in the tested range of 2k-8k rpm, forming the critical boundary line. The drilling performance of the micro-drills can be evaluated quantitatively by using the position of the critical boundary lines in the space of feed speed vs. rotation rate: the upper the critical boundary line, the higher the drilling performance of the micro-drill.

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/AMM.619.49.pdf

Reference14 articles.

1. W. -C. Choi and J. -Y. Ryu: Microsystem Technol. 17 (2011), p.143.

2. D.G. Grossman and D. L. Taylor, in The Science of Ceramic Machining and Surface Finishing, edited by B.J. Hockey and R.W. Rice, NBS Special Publication 562 volume 2, US Government Printing Office, Washington DC (1979), p.221.

3. R.W. Rice and B.K. Speronello: J. Am. Ceram. Soc. 59 (1976), p.81330.

4. P. Roth and H.K. Tonshoff, in : Machining of Advanced Materials, edited by S. Jahanmir, NIST Special Publication 847, US Government Printing Office, Washington DC (1993), p.247.

5. C. Guo and R.H. Chand: Ceram. Eng. Sci. Proc. 17 (1996), p.215.