Effect of Cutting Speed and Feed on Deep Drilling-Reference-Cited by-同舟云学术

Effect of Cutting Speed and Feed on Deep Drilling

Published:2014-12 Issue: Volume:693 Page:388-393
ISSN:1662-7482
Container-title:Applied Mechanics and Materials
language:
Short-container-title:AMM

Author:

Letavay Martin¹,Pilc Jozef²,Stancekova Dana²

Affiliation:

1. GeWiS - Slovakia s. r. o.

2. University of Zilina

Abstract

The article describes the deep drilling tests of internal company research, which is aimed to determine the geometric tolerances as run-out, roundness and roughness, but also the shape and size of chips depending on cutting parameters. Further exploration subject was recorded using the actual engine power to determine the torque and axial force required for removing particles at the given cutting parameters. The results served to increase the productivity of deep drilling operations within the optimization process.

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/AMM.693.388.pdf

Reference9 articles.

1. Czan, A., Tillova, E., Semcer, J., Pilc, J., Surface and Subsurface Residual Stresses after Machining and their Analysis by x-ray Diffraction, Comunications No. 2, 69-76, (2013).

2. Cep, R., Janasek A., Petru J., Cepova L., Czan A., Valicek J., Hard Machinable Machining of Cobalt-based Superalloy, Manufacturing Technology, XIII/13, 2013, 226-231.

3. Litvaj, I., Ponisciakova, O., Stancekova, D., Drbul, M., Knowledge Processes and their Im-plementation in Small Transport Companies, Kaunas, October 2013, Code 102486, 153-156.

4. Vasilko, K., Pilc, J., New Technological Knowledge of the Rotary Turning Tool, J. Manufacturing Technology, vol. 13, No. 4, December 2013, 571-575.

5. Holesovsky, F., Naprstkova, N., Novak, M.: GICS for Grinding Process Optimization. Manufacturing Technology, XII/12, 2012, 22-26.