Changing Deformation under the Machined Surface in the Cutting Zone for the Different Materials during Drilling-Reference-Cited by-同舟云学术

Changing Deformation under the Machined Surface in the Cutting Zone for the Different Materials during Drilling

Published:2014-07 Issue: Volume:607 Page:145-148
ISSN:1662-7482
Container-title:Applied Mechanics and Materials
language:
Short-container-title:AMM

Author:

Jurko Jozef¹,Panda Anton¹,Behún Marcel²

Affiliation:

1. TU Kosice

2. Technical University in Košice

Abstract

The basic hypothesis of this article focuses on the changes in the plastic deformation under the machined surface during drilling. For experiments applied a new Cast Iron GTW 35-04, Stainless steels DIN 1.4301 and ISO C45 carbon steel. The problem of drilling holes with diameter D=2 to 15 mm resides in the fact that 20 to 30% of these holes do not comply with prescribed requested requirements. This article presents the results of experiments focusing on the study of the damage process in helical drills with diameter d=6.0 mm. This study also includes an analysis of accompanying phenomena in the cutting zone by measuring some selected parameters.

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/AMM.607.145.pdf

Reference15 articles.

1. E.W. Brinksmeier, A. Reucher, J. Griet-Solter, Influence of characteristic material properties on machinability under high speed cutting, International Journal of Machining and Machinability of Materials, Vol. 4, No. 4, 2008, pp.419-428.

2. J. Jurko, A. Panda, M. Behún, J. Gecák, Effect of machinability of stainless steels for increasing of productivity production, Applied Mechanics and Materials, Vol. 378, No. 378, 2013, pp.154-158.

3. J. Jurko, A. Berdis, J. Panda, J. Gecák, J. Nemcová, Study of changes the tool wear of the cutting tool part of a new cast iron GTW 35-04 during drilling, Applied Mechanics and Materials, Vol. 404, No. 404, 2013, pp.82-85.

4. J. Jurko, A. Panda, M. Gajdoš, Accompany-ing phenomena in the cutting zone machinability during turning of stainless steels,. International Journal Machining and Machinability of Materials, Vol. 5, No. 4, 2009, pp.383-400.

5. J. Jurko, Verification of cutting zone machinability during drilling of austenitic stainless steels, ICEM 2008: International Conference on Experimental Mechanics SPIE, Vol. 7375, No. 7375-1H, 2008, pp.367-378.