Novel Prediction Analysis Method for Error Separation of Stylus System and CMM Machine-Reference-Cited by-同舟云学术

Novel Prediction Analysis Method for Error Separation of Stylus System and CMM Machine

Published:2014-02-27 Issue: Volume:875-877 Page:671-679
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Ramadan Ali Salah Hamed¹

Affiliation:

1. National Institute for Standards (NIS)

Abstract

Coordinate Measuring Machine (CMM) is nowadays widely used for a large range of accurate and precise dimensional measurements. The strategy of µ-scale measurement is expected to carry out with ever-increasing performance in term of root error separation for stylus system and CMM machine accuracy. The experimental analysis method in this paper aims to study the effect of dynamic root errors at different undulations per revolution (UPR) response of artifact measurement using selected two types of CMM touch-triggering stylus. Direction of stylus characteristics and stylus speed parameters were adopted and emphasized upon throughout the course of experiment. The results were investigated using Fourier analysis could thus be derived to ensure foreseeable accurate and precise results of CMM machine and stylus errors. Some specific error equations for stylus system and machine responses have been postulated and analysed empirically. The results may also employ validating an experimental investigation to detection accuracy development using PRISMO-Bridge-CMM-type in NIS.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.875-877.671.pdf

Reference16 articles.

1. Salah H.R. Ali: Advanced Measuring Techniques in Dimensional and Surface Metrology, The 10th Int. Scientific Conf. of Coordinate Measuring Technique, IMEKO-CT14, Bielsko-Biała, Poland, (23rd-25th April 2012).

2. B. Muralikrishnan and J. Raja: Computational Surface and Roundness Metrology Book, ISBN 978-1-84800-296-8, Springer, (2009), pp.13-14.

3. Salah H.R. Ali, H.H. Mohamad and M.K. Bedewy: Identifying Cylinder Liner Wear using Precise Coordinate Measurements, International Journal Of Precision Engineering and Manufacturing Vol. 10, No. 5, (Dec. 2009), pp.19-25.

4. Salah H.R. Ali, M.K. Bedewy and Sarwat. Z. Zahwi: Dimensional Inspection of Overhauled Automotive Water-Cooled Diesel Engines, Proceeding of the Int. Conference of Production Eng., Design, and Automatic Control, PEDAC'09, Alexandria, Egypt, 10-12 Feb. (2009).

5. Adam Wozniak and Marek Dobosz: Research on Hysterias of Triggering Probes Applied in Coordinate Measurement Machine, Journal of Metrology & Measurement Systems, Poland, Vol. XII, No. 4, (2005), pp.393-412.

Cited by 2 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. New Developments in Smart Materials (WCS and CNTs) for Precision Engineering Metrology;SAE Technical Paper Series;2023-04-11

2. Chapter 7: Factors Affecting the Performance of Talyrond Measurement Accuracy;Automotive Engine Metrology;2016-08-31