Abstract
Based on the forming technology of "hollow laser beam and internal powder, adopting a novel device with coaxial inside-beam and internal powder feeding, the accumulation experiments of the change-diametral rotary parts are carried out on the substrate of 45# steel. This study is focused on the control of the parts inclination angle, Z axis incremental and laser power on the forming characteristics of the parts. The results show that with the Coaxial Inside-beam Powder Feeding Accumulation, the quality of molding parts that this experiment gets finally is higher with smooth appearance and lower roughness. The grain is fine and the microstructure distribute uniformly from bottom to top of forming parts.
Publisher
Trans Tech Publications, Ltd.
Reference7 articles.
1. Wang HM, Duan G. Wear and corrosion behavior of laser clad Cr3Si reinforced intermetallic composite coatings. Intermetallics 2003; 11: 755–62.
2. Tan H, Chen J, Zhang FY, Lin X, Huang WD. Process analysis for laser solid forming of thin-wall structure. Int J Mach Tools Manu 2010; 50: 1–8.
3. Shan MG, Guo LL, Zhong Z. Design and characterization of harmonic diffractive microlens arrays with continuous relief for parallel laser direct writing. Opt Lasers Eng 2010; 48(3): 340–5.
4. Li Lun, Liu Weijun, Shang Xiaofeng. Direct metal deposition based on revolving surface[J]. Journal of Basic Science and Engineering. 2008, 16(4): 616~626.
5. Wang Jiajin. Laser Processing Techniques[M]. Beijing: Chinese Metrology Press. 1992. 50~60.