Affiliation:
1. Nanjing University of Information Science and Technology
Abstract
In this paper, according to the requirements of some cam component in rotary press, cubic NURBS spline is used to generate the contour of cam after calculating every control point on the basis of movement requirement of driven part. And software ADAMS is used to verify the calculation result. Results show this method is an effective way for manufacturers of rotary press to generate cam contour, which can improve the performance of cam mechanism and save much time.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Reference10 articles.
1. Q. Wang, C. R. Chatwin, A. Geha, R. C. D. Young and D. M. Budgett: Int. J Adv Manuf Technol Vol. 19(2002), pp.142-150.
2. S.W. Hong: Printing World, Vol. 1(1999), pp.25-26.
3. Z.G. Yang: Printing World Vol. 1(2006), pp.1-3.
4. C. Kai, W. David: Int. J Adv Manuf Technology Vol. 30 (2006), pp.909-910.
5. A. G. Mamalis, N. G. Bilalis and V. S. Ganovsky: Int. J Adv Manuf Technol Vol. 7 (1992), pp.44-50.