Affiliation:
1. Huaiyin Institute of Technology
Abstract
It was hard to predict crack and wrinkle which are the main failure modes when drawing for the shallow tapered parts. In this paper crack and wrinkle can be avoided effectively by using the software DYNAFORM in combination with orthogonal design of experiment method. The influence of normal anisotropy coefficient, friction coefficient, drawbead resistance and blank holding force on deep drawing shallow tapered surface was analyzed by numerical simulation. The results show that the minimum-wall-thickness was the main criterion for the drawing process but not the only criterion. Crack and wrinkle can be moderately eliminated finally after optimization of the parameters and following trim process in the drawing for shallow tapered surface.
Publisher
Trans Tech Publications, Ltd.
Reference12 articles.
1. H.Y. Qiu, Y.J. Huang, Q. Liu, The study of engine hood panel forming based on numerical simulation technology. Journal of Materials Processing Technology, 2007, 12(187): pp.140-144.
2. X.G. Qiu, W. L Chen, The study on numerical simulation of the laser tailor welded blanks stamping. Journal of Materials Processing Technology, 2007, 12(187): pp.128-131.
3. Y.L. Ren, Y.C. Lu, J.G. Peng, Effect of relative thickness on tapered part drawing. Journal of Mechanical Engineering, 2010, 8(46): pp.51-55.
4. J.G. Peng, Y.L. Ren, Study on thin wall tapered shell drawing instability condition. Journal of Plasticity Engineering, 2006, 5(13): pp.72-75.
5. M. Strano, A technique for FEM optimization under reliability constraint of process variables in sheet metal forming. International Journal of Material Forming, 2008, 1(1): pp.13-20.