Affiliation:
1. International Islamic University Malaysia
2. Manufacturing Engineering Centre
Abstract
Selective Laser Sintering (SLS) or Laser Sintering (LS) allows functional parts to be produced in a wide range of powdered materials using a dedicated machine, and is thus gaining popularity within the field of Rapid Prototyping (RP). One of the advantages of employing LS is that the loose powder of the building chamber can be recycled. The properties of polymer powder significantly influence the melt viscosity and sintering mechanism during Laser Sintering (LS) processes which results in a good surface finish. The objective of this research is to investigate the chemical composition of fresh polymer materials used in Laser Sintering. There are seven virgin SLS materials which are PA2200, GF3200, Alumide, PrimeCast, PrimePart, Duraflex and CastForm. Fourier Transform Infrared Spectroscopy (FTIR) was used to analyze the chemical composition of the materials by using infrared radiation and absorbed frequency. The spectra show that similar functional groups were found in the materials apart from PrimePart and Duraflex. Obtained data from this analysis could be used to investigate on how the fresh and recycled powder materials with different chemical properties would affect the part surface finish.
Publisher
Trans Tech Publications, Ltd.
Reference5 articles.
1. WAY Yusof, Muhammad Ridhuan Kamarudin, Noor Iliana Mohd Salimi, The Application Reverse Engineering Tools and Rapid Prototyping Technology in Developing Automotive Components. Advanced Materials Research, Trans Tech. publications, Switzerland, Vol. 576 (2012).
2. PK Jain, K Senthilkumaran, PM Pandey, PVM Rao, (2006) Advances in materials for powder based rapid prototyping, Proceeding of International Conference on Recent Advances in Materials and Processing.
3. Subha K. Kumpaty, Deborah Cottrill, Andrew Hollett, Jon Barrett and Sheku Kamara, An Experimental Study of Heat Transfer in SelectiveLaser Sintering™ process, (2006) 9th International Conference on Engineering Education.
4. D T Pham, K D Dotchev, WAY Yusoff, Deterioration of polyamide power properties in the laser sintering process, Journal of Mechanical Engineering Science IMeche, Part C, Vol. 222. no. 11, pp.2163-2176, (2008).
5. WAY Yusoff, Hasanudin Hafis Mohamad Ali, Md. Amir Hamzah Md. Shukri, Fabrication of Surgical Cranioplasty Biomodel Using Fused Deposition Modeling, Institute of Electrical and Electronics Engineers ( IEEE ) pp.550-554, (2012).