Mould Running System Design to Achieve the Minimum Waste-Reference-Cited by-同舟云学术

Mould Running System Design to Achieve the Minimum Waste

Published:2014-05 Issue: Volume:933 Page:963-968
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Monkova Katarina¹,Monka Peter¹,Cizikova Andrea¹,Hric Slavomir¹

Affiliation:

1. Technical University Košice

Abstract

The article deals with the mould running system design. The goal of design presented in the article was to propose the mould form so to be achieved the minimum waste for selected component. Studied component is intended to serve as a stopper in the automotive spotlight. The waste is considered the material that solidifies in the volume of plastic inside the running system. 3D model of the mould was created in Autodesk Inventor Proffesional software and then solidification of material was simulated in Autodesk Moldflow Insight software. There were designed three alternatives of running system at which the waste amount was evaluated. On the basis of the best solution, the real form was manufactured and placed into the injection moulding machine Arburg Allrounder 320 C.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.933.963.pdf

Reference9 articles.

1. Ress, H., C.: Selecting Injection Molds – Weighing Cost versus Productivity, Hanser Publishers, (2006).

2. Spisak, E., Majernikova, J.: Analysis of variance of mechanical properties of sheets as the input parameters for simulation of processes, In: Acta Metallurgica Slovaca, Vol. 18, no. 2-3, (2012) pp.109-116.

3. Pantani, R. et al.: Analysis of Gate Freeze-Off Time in Injection Molding, Polymer Engineering and Science, (2004).

4. Pasko, J. et al.: Influence of technological parameters of die castning on qualitative properties of castings, In: Manufacturing engineering and technology, no. 1, (2010), pp.3-6.

5. Kadnar M. et al.: The design and verification of experimental machine for real journal bearing testing, Technical Gazette, Vol. 18, no. 1, (2011), pp.95-98.