Novel Jump Control for Debris Processes of Electrical Discharge Machining with Direct-Drive Spindle-Reference-Cited by-同舟云学术

Novel Jump Control for Debris Processes of Electrical Discharge Machining with Direct-Drive Spindle

Published:2010-03 Issue: Volume:97-101 Page:4178-4181
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Hsue Albert Wen Jeng¹,Chung Chih Hung¹

Affiliation:

1. Dahan Institute of Technology

Abstract

Owing to its low removal rate and debris ejection nature, EDM is a very slow machining process. A novel jump motion control for electrode in electrical discharge machining (EDM) equipped with dual linear motors (LmEDM) was proposed to release this debris efficiency point. The direct drive EDM and a novel pulse discriminator were developed. By introducing the discriminator to count effective discharge pulses, an EDM jump control was proposed. Experiments for verification of the EDM efficiency were conducted for 35 mm deep and thin EDM processes with 2 mm thin platelet. EDM efficiency of proposed jump control is verified to be four times over the traditional EDM.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.97-101.4178.pdf

Reference10 articles.

1. S. Cetin, A. Okada, and Y. Uno, J. Manuf. Sci. and Eng., Tran. ASME (2003), 125, p.809.

2. T. Kaneko and H. Yamada, Int. J. of Elec. Mach. (2000), 5, p.59.

3. Y. Zhao, X. Zhang, X. Lin, and K. Yamazaki, Int. J. of Mach. Tools & Manuf. (2004), 44, p.1.

4. T. Masuzawa, and C. J. Henuvelman, J. of Jap. Soc. of Prec. Eng. (1985) 51-7, p.112.

5. T. Kaneko, and M. Tsuchiya, Int. J. of Elec. Mach. (1997) No. 2, p.37.

Cited by 4 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Analysis of interelectrode gap in μEDM and energy dissipation in single discharge: A review;Materials Today: Proceedings;2021

2. Dynamic Behaviour of Spindle on Large EDM Machine Induced by High-Speed Jump Motion with Different Control Strategies;Arabian Journal for Science and Engineering;2020-02-27

3. PULSE DISCRIMINATION FOR ELECTRICAL DISCHARGE MACHINING WITH ROTATING ELECTRODE;Machining Science and Technology;2013-04

4. Improving the Speed of Small Deep Hole Electrical Discharge Machining by Combining Rotation of the Electrode with a Rapid-Response;Journal of Advanced Mechanical Design, Systems, and Manufacturing;2011