HSC Linear Motor Machine Dynamic Stiffness-Reference-Cited by-同舟云学术

HSC Linear Motor Machine Dynamic Stiffness

Published:2015-07 Issue: Volume:772 Page:218-223
ISSN:1662-7482
Container-title:Applied Mechanics and Materials
language:
Short-container-title:AMM

Author:

Pandilov Zoran¹,Dukovski Vladimir¹

Affiliation:

1. University “Sv. Kiril i Metodij”-Skopje

Abstract

In this paper a model of the feed drive system with disturbance force for High Speed Cutting (HSC) linear motor machine is given. The dynamic stiffness for the proposed model is analysed. A simulation of the influence of some parameters on feed drive dynamic stiffness is performed with the simulation program MATLAB & SIMULINK. Correctness of the proposed model is verified with an experimental measurement of the dynamic stiffness of the feed drive on the prototype HSC linear motor machine (HSC 11).

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/AMM.772.218.pdf

Reference10 articles.

1. Ebrahimi M., Whalley R.: Analysis, modeling and simulation of stiffness in machine tool drives Computers & Industrial Engineering, Volume 38, Issue 1, January 2000, p.93–105.

2. Elfizy A. T., Bone G. M., Elbestawi M.A.: Design and control of a dual-stage feed drive, International Journal of Machine Tools and Manufacture, Volume 45, Issue 2, February 2005, p.153–165.

3. Jamaludin Z., Brussel H.V., Swevers J.: Classical cascade and sliding mode control tracking performances for a x-y feed table of a high-speed machine tool, International Journal of Precision Technology Volume 1, Number 1/2007, pp.65-74.

4. Kakino Y., Matsubara A., Li Z., Ueda D., Nakagawa H., Takeshita T., Maruyama H.: A study of the Total Tuning of the Feed Drive System in NC Machine Tools (4th report)-Multiple Axes Tuning. Journal of the Japan Society of Precision Engineering Vol. 63, No. 3, 1997, pp.368-372.

5. Kakino Y., Matsubara A., Li Z., Ueda D., Nakagawa H., Takeshita T., Maruyama H.: A study of the Total Tuning of the Feed Drive System in NC Machine Tools (2nd report)-Single Axis Servo Parameter Tuning, Journal of the Japan Society of Precision Engineering Vol. 61, No. 2, 1995, pp.268-272.