Affiliation:
1. Erode Sengunthar Engineering College
2. Angel College of Engineering and Technology
3. Bharath University
4. Sri Sairam Institute of Technology
Abstract
Improving the Material Removal Rate (MRR), reduce Tool Wear Rate (TWR), achieve the good Surface Finish (SF) and Over Cut (OC) are very demanding in Electrical Discharging Machining (EDM). This paper focused on performance of Silicon powder mixed with kerosene servotherm dielectric medium in EDM of Monel 400. The optimum range of Silicon powder, Graphite powder 6g mixes with the dielectric medium of kerosene servotherm (75:25) were developed experimentally. It was reported slightly more MRR, very low TWR, better OC and good surface finish (SF) in Monel 400.
Publisher
Trans Tech Publications, Ltd.
Reference15 articles.
1. Anand Pandey, Shankar Singh , Current research trends in variants of EDM, International journal of Engineering Science and Technology, 2 (6), ( 2010. ), 2172-2191.
2. Sengottuvel, P., Satishkumar, S. and Dinakaran, D, Optimization of Multiple Characteristics Of EDM Parameters Based on Desirability Approach And Fuzzy Modeling. Journal of Procedia Engineering, . 64(2013), 1069-1078.
3. Sengottuvel, P., Satishkumar, S. and Dinakaran, D, Multi Objective Optimization of Process Parameters during Electrical Discharge Machining of Inconel 718 Using Desirability Approach. International Journal of Applied Mechanics and Materials, l. 159(2012).
4. Nikhil Kumar, Lalit Kumar, Harichand Tewatia, and Rakesh yadav , Comparative Study for MRR on die-sinking EDM using electrode of copper and graphite. International journal of advanced technology & engineering research, 1(2), (2012), 170-174.
5. .