Coatings and Lubricant to Forming Surfaces of Molds for Casting under Pressure-Reference-Cited by-同舟云学术

Coatings and Lubricant to Forming Surfaces of Molds for Casting under Pressure

Published:2021-04 Issue: Volume:316 Page:789-793
ISSN:1662-9779
Container-title:Solid State Phenomena
language:
Short-container-title:SSP

Author:

Gavariev R.V.¹,Soldatkina E.N.¹,Gavarieva K.N.²

Affiliation:

1. Kazan National Research Technical University named after A.N. Tupolev - KAI

2. Kazan Federal University

Abstract

The article considers the main points for choosing lubricants, taking into account the specifics of the injection molding process. The main drawbacks of modern lubricant compositions are identified, and based on them, the main requirements for lubricants for injection molding are determined. The most critical parameters of lubricants are specified, depending on the melt to be filled. The methods of applying lubricants are considered, and the most optimal ones are selected.

Publisher

Trans Tech Publications, Ltd.

Subject

Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics

Link

https://www.scientific.net/SSP.316.789.pdf

Reference20 articles.

1. Sanz A. New coatings for continuous casting rolls // Surface and Coatings Technology. (2004) vol. 177-178. pp.1-11. https://doi.org/10.1016/j.surfcoat.2003.06.024.

2. Pivovarchic A.A. Erozionnaya stojkost razdelitelnyh pokrytij pri litye pod davleniem al-splavov / Litejnoe proizvodstvo, (2017) vol. 1, pp.23-26.

3. Gavariev R.V., Savin I.A., Improvement of surface quality of casting produced by casting under pressure // Solid State Phenomena (2017) vol.265, pp.988-993.

4. Pankratov D.L., Gavariev R.V., Improving the quality of castings made of non-ferrous metal alloys when casting in metal molds // IOP Conf. Series: Materials Science and Engineering 570 (2019) 012072.

5. Gavariev R.V., Savin, I.A., Research of the Mechanism of Destruction of Compression Molds for Casting under Pressure of Color Alloys // Solid State Phenomena (2018) Vol. 284, pp.326-331.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. The analysis efficiency of the demulation agent injected into aluminum molds;Tribology International;2023-01