Affiliation:
1. Changsha University of Science and Technology
2. Hunan University
Abstract
Abstract. Embedded K nickel chrome-nickel silicon thermocouple was used to measure the grinding temperature of stainless steel in the cases of high-speed grinding while machining SUS304 Stainless Steel with vitrified CBN wheels in high speed grinding conditions.The energy partition is approximately 7.7% by matching the measured temperature to the analytically computed temperature. 3D FEM simulations for some typical grinding conditions are carried out.The error between the simulation analysis temperature results and the experimental results is approximately 3% on the grinding surface,and the error between the simulation analysis temperature results and the experimental results is approximately 10% below the grinding surface.
Publisher
Trans Tech Publications, Ltd.
Reference10 articles.
1. Kohli,S. P, Guo. C, and Malkin. S, Energy Partition for Grinding with Aluminum Oxide and CBN Abrasive Wheels, ASME Journal of Engineering for Industry, 1995, Vol. 117, 160-168.
2. R. Snoeys,M. Maris,J. Peters, Thermally induced damages in grinding, Ann. CIRP 27 (2) (1978) 571-581.
3. Wu. Yiwen, Hua. Yi, Xu. Chengmin, Wu. Haili, Statistical analysis on performance of imported SUS304 cold-rolled stainless steel plates, Inspection and quarantine science 2007, 17(1)32-36.
4. V. Varghese, C. Guo, S. Malkin, and G. Xiao, Energy partition for grinding of nodular cast iron with vitrified CBN wheels, Machining Science and Technology, 4(2), 197-208 (2000).
5. N.K. Kim,C. Guo,S. Malkon, Heat Flux Distribution and Energy Partition in Creep-Feed Grinding, Annals of the CIRP Vol. 46/1/(1997).
Cited by
3 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献