Affiliation:
1. Yonsei University
2. Seoul National University
3. Yonsei University, College of Dentistry
Abstract
Dental impression materials are used to register or reproduce the form and relationship of the teeth and oral tissues. They should not be torn when removing from the wet mouth after setting. Nowadays, silica is widely used as filler to overcome the low mechanical strength of the dental impression materials. The purpose of this study was to synthesize high strength glass in the system of
MgO-CaO-Al2O3-SiO2 and investigate its usefulness according to ISO standard after mixing with addition silicone. Commercial products, Contrast, Examix, Express, and Perfect-F were selected as control group. When the prepared glass filler was introduced in addition silicone impression material, tear strength was drastically increased significantly than that of the control group, keeping the consistency. All experimental groups showed higher tear stength than that of control groups. As the
amount of filler content increases, tear strength was increased. Strain in compression, recovery from deformation, and linear dimensional change were satisfied the ISO standard either all the experimental or control groups. Therefore, calcium-substituted magnesium aluminosilicate glass in the system of 12.5MgO-17.5CaO-20Al2O3-50SiO2 is expected the useful filler in the light body of addition silicone impression materials.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Reference5 articles.
1. A.H.L. Tjan and W.H. Heisler, Am. J. Dent., Vol. 5 (1992), p.223.
2. J.P. de Wald et al., J. Prosthet. Dent., Vol. 71 (1994), p.394.
3. M.N. Mandikos, Aust. Dent. J., Vol. 43 (1998), p.428.
4. W.J. Finger, Dent. Mater., Vol. 4 (1998), p.33.
5. H. Makato et al., J. Japn. Soc. Dent. Mater. Dev., Vol. 9 (1990), p.326.