Machining Efficiency Increase when Nickel Based Alloy Machining
-
Published:2017-08
Issue:
Volume:261
Page:22-27
-
ISSN:1662-9779
-
Container-title:Solid State Phenomena
-
language:
-
Short-container-title:SSP
Author:
Matras Andrzej1,
Zębala Wojciech1
Affiliation:
1. Cracow University of Technology
Abstract
Paper presents some investigations, concerning simulation of the nickel based alloy machining. The aim of the research was an optimization of the cutting data for the purpose to increase the machining efficiency and stabilization of the tangential component of the total cutting force at the assumed level. A dedicated physical material model was built and then included to the simulation strategy. Authors demonstrated the influence of the feed rate optimization on the tangential component of the total cutting force value changes and the chip area and in this way the improvement of the cutting process.
Publisher
Trans Tech Publications, Ltd.
Subject
Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献