Effect of Water Jet and Electroerosion Cutting on Fatigue Strength of Thick Al-Alloy Sheet-Reference-Cited by-同舟云学术

Effect of Water Jet and Electroerosion Cutting on Fatigue Strength of Thick Al-Alloy Sheet

Published:2010-01 Issue: Volume:636-637 Page:1525-1530
ISSN:1662-9752
Container-title:Materials Science Forum
language:
Short-container-title:MSF

Author:

Černý Ivo¹,Mikulová Dagmar¹

Affiliation:

1. SVÚM a.s

Abstract

Results of an experimental investigation of effects of two advanced technologies for materials cutting, namely water-jet and electroerosive cutting, respectively, are described. Water jet cutting, with abrasive particles and specific parameters, and electroerosive cutting were applied to an aircraft Al-alloy sheet Al 2124 T851 of a considerable thickness, namely 50.8 mm. Reference batch of specimens was manufactured using fine finishing milling. Surface quality of each of the cutting and machining technologies was evaluated and fatigue strength was investigated. Three point bend fatigue tests performed at constant stress amplitude showed a considerable deterioration effect of both technologies on fatigue strength. The damaging effect of both technologies was comparable. Fractographical analysis using scanning electron microscopy (SEM) showed fatigue crack initiation in numerous surface micro-notches occurring as a result of the cutting. In addition, the crack initiation was frequently accelerated by surface or subsurface fairly large particles of intermetallic phases. This mechanism also occurred with milling specimens.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

https://www.scientific.net/MSF.636-637.1525.pdf

Reference7 articles.

1. H.T. Zhu, C.Z. Huang, J. Wang, X.Z. Lu and Z.X. Feng: Int. J. of Materials and Product Technology, Vol. 31 (2007), No. 1, p.106.

2. N. Geren, M. Bayramoğlu and U. Esme: J. of Engineering Design, Vol. 18 (2007), 2007, p.13.

3. M. Jou: J. of Materials Processing Technology, Vol. 104, No. 1, 2000, p.17.

4. F.L. Chen and E. Siores: J. of Materials Processing Technology, Vol. 135 (2003), No. 1, p.1.

5. J. Polák: Key Engng. Materials, Vols. 348-349 (2007), p.113.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Fatigue properties of a low alloy 42SiCr steel heat treated by quenching and partitioning process;Procedia Engineering;2011