Abstract
Accuracy of abrasive waterjet cutting mainly depends on the form of cutting gap. It is very difficult to keep in hand the taper of the gap and produce almost parallel cut surfaces. There are a lot of parameters having effect on the gap. Results of a complex investigation have not been published in the literature. Taper can change at different materials and depends on the applied technological parameters (feed rate, pressure, abrasive flow rate etc.). Some results of research work carried out on AlMgSi0.5 alloy related to the taper of the cutting gap are explained in this paper, mainly from point of view of the load energy which effect to the surface of the workpiece during abrasive waterjet cutting.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Reference6 articles.
1. Momber, - Kovacevic, R.: Principles of Abrasive Water Jet Machining, Springer ed., 1998, pp.394-2.
2. C. Öjmertz: A Study on Abrasive Waterjet Milling, Thesis for the Degree of PhD Chalmers University of Technology Göteborg Sweden, 1997, p.81.
3. Chung, Y. -, Geskin, E.S. - Singh, P.: Prediction of the Geometry of the Kerf Created in the Course of Abrasive Waterjet Machining of Ductile Materials. In: Jet Cutting Technology, Kluwer, Dordrecht, 1992, pp.525-541.
4. Arola, D. - Ramulu, M. : A Study of Kerf Characteristics in Abrasive Waterjet Machining on Graphite/Epoxi Composite, Journal of Engineering Materials and Technology, Transaction of the ASME, 1996 118(2), pp.256-265.
5. Louis, H.: Abrasive water jets: a review, 5th Pacific Rim International Conference on Water Jet Technology, February 3-5, 1998, New-Delhi India, pp.321-329.
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
1. Machining of rotationally symmetric parts with abrasive waterjet;IOP Conference Series: Materials Science and Engineering;2018-11-30