Experimental Studies of Deformation and Temperature Processes Mandrelling in the Deform-3D System-Reference-Cited by-同舟云学术

Experimental Studies of Deformation and Temperature Processes Mandrelling in the Deform-3D System

Published:2021-07-06 Issue: Volume:1037 Page:357-368
ISSN:1662-9752
Container-title:Materials Science Forum
language:
Short-container-title:MSF

Author:

Selemenev Mikhail F.¹,Cherepenko Arkady A.¹,Zvyagina Elena A.¹,Tkachenko Artem N.¹,Selemeneva Elena M.¹

Affiliation:

1. Oryol State University named after I.S. Turgenev

Abstract

The article discusses the effect of epilamated coatings during mandrelling. The picture of the change in contact stresses in the DEFORM-3D system is presented. It was established that a decrease in the coefficient of friction from 0.9 to 0.6 leads to a decrease in the number of foci and areas of contact stresses, as well as temperature analysis showed that a decrease in the friction forces reduces heat transfer in the cutting zone by about 40 ° C.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

https://www.scientific.net/MSF.1037.357.pdf

Reference12 articles.

1. Kirichek A.V., Selemenev M.F., Semenkin G.N., Osipova A.F. Principles of using the epilamated tool for mandrel cutting // Fundamental and applied problems of engineering and technology ": - №5 / 2 (283) .- Orel: IPC OrelSTU, 2010-3p .- .pp.20-23.

2. Bizyaev, GN Modeling of the stress-strain state during mandrel-ring blanks [Text] / GN Bizyaev // Problems of efficiency and operation of internal combustion engines: materials of the interstate. scientific and technical seminar / SSAU. - Saratov, 2007. -No. 19.pp.111-114.

3. Kritsky A.D., Lobanova L.V., Komarov A.A. On the issue of processing thin-walled parts by deforming broaching '// Increasing the efficiency of broaching. Riga: Riga. Polytechnic Institute, 1990, pp.89-92.

4. Gromov N.P. Theory of metal forming. M .; Metallurgy, 1967.-340 p.

5. Grudev A.D., Zilbert Yu.V., Tilik V.T. Friction and lubrication in metal forming. Moscow: Metallurgy, 1982.312 p.

Cited by 2 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Combined Processing of Flat End Surfaces of Electrical Parts;Key Engineering Materials;2022-02-15

2. Efficiency of Application of Epilams when Protecting the Surface of Fast Cutting Tools;Key Engineering Materials;2022-02-15