Abstract
Spinning is a type of plastic forming in which a tool such as a roller is pressed against a rotating plate or tube to gradually deform the shape and obtain a product with the same shape as the forming die. This processing method has the advantage that it can be processed seamlessly but has the drawback of causing internal defects due to deformation. In this study, the purpose is to obtain basic knowledge about the internal defect generation mechanism in spinning, and to perform cold and hot spinning with high diameter reduction under various conditions on Al-Mg-Si alloy tube. From the experimental results, it was confirmed that the inner defects increased as the diameter reduction ratio increased. It was considered that the main cause of the occurrence of inner defects was that, at a high diameter reduction ratio, the amount of processing was large, so that the increase of material flow led to increase of wall pressure.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference4 articles.
1. Hayama Masujiro, Murota Tadao, Study of Shear Spinning, Bulletin of the JSME, 1963, Vo.3, pp.1458-1466.
2. Hayama Masujiro, Murota Tadao, Study of Shear Spinning, Bulletin of the JSME, 1963, Vo.3, pp.1458-1466.
3. Nakasato Shunichiro, Kobayasi Junya, Itoh Goroh, The effect of the forming die on spinning of A1070 and A6063, THE PROCEEDINGS OF THE 2017 JAPANESE SPRING CONFERENCE FOR THE TECHNOLOGY OF PLASTICITY, 2018, pp .89-90.
4. EUROPEAN INDUSTRIAL GASES ASSOCIATION AISBL, RECOMMENDATIONS FOR AVOIDANCE OF SUSTAINED LOAD CRACKING OF ALUMINUM ALLOY CYLINDERS. (2011).