Low-Temperature and Rapid Fabrication of Bulk Nano-TiO2 Ceramic

Abstract

A self-made sectional die made of high-performance graphite, SiC ceramic and Ni-based superalloy was firstly designed and developed. The TiO2 ceramic, with original TiO2 powders of average particle size ~25 nm and 80 wt.% anatase + 20 wt.% rutile, was fabricated by plasma activated sintering (PAS) at 500600 °C for 3 min under applied uniaxial pressure of 2001000 MPa using the sectional die. The influences of sintering temperature and applied pressure on the density, phase transformation and grain growth of the TiO2 ceramic were investigated. The results showed that the sintering temperature and applied pressure played key roles in determining the relative density, phase composition and grain size of the TiO2 ceramic. The relative density and grain size increased and the anatase phase transformed into the rutile phase slowly or quickly as the sintering temperature or the applied pressure increased. In particular, the increase of sintering temperature was very advantageous to the phase transformation, and the increase of applied pressure was quite effective to inhabit the grain growth. All the averaged grain sizes of TiO2 ceramics were less than 100 nm in the present experimental conditions. Moreover, the relative density of the sintered ceramic were over 95% when the optimized sintering parameters were 600 °C × 500MPa or 500 °C × 1000MPa. The TiO2 ceramics were composed of only the rutile phase when the applied pressure and the sintering temperature were not less than 300 MPa and 550 °C, respectively.