Wearability of SiC<sub>P</sub> Particle Reinforced Aluminum Matrix Composites Creeper Tread-Reference-Cited by-同舟云学术

Wearability of SiC_P Particle Reinforced Aluminum Matrix Composites Creeper Tread

Published:2011-07 Issue: Volume:299-300 Page:727-734
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Du Zhi Ming¹,Qin Jin¹,Liu Jun¹,Chen Gang¹,Jia Hai Meng¹,Xie Shui Sheng²

Affiliation:

1. Harbin Institute of Technology

2. Beijing General Research Institute for Non-Ferrous Metals

Abstract

Wearability of SiCpreinforced aluminum matrix composites creeper treads was studied. Wear resistance of these creeper treads was tested by sliding friction pin-disk tester at room temperature. Friction morphology was observed and the friction mechanism of these creeper treads was investigated. The experiment parameters such as SiCpparticle size, volume fraction, mixing temperature, mixing time were adjusted and the best parameters were found through the tests. The results showed that the creeper tread had the most excellent wearability, high strength and hardness with 875r/min mixing speed, 40min~60min mixing time, 660°C~700°C mixing temperature, 7μm SiCpparticle size and the 10vol% SiCpvolume fraction. There were no microscopic holes and other defects in these dense composite materials. The interface between SiCpand Al matrix was clean and straight, where Al4C3brittle phase wasn't observed.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.299-300.727.pdf

Reference15 articles.

1. J.W. Kaczmar, K. Pietrzak, W. Wlosinski.: Journal of Materials Processing Technology. Vol. 106(2000), p.58.

2. Zhang Jiliang, Han Wenzheng, Liu Shican, etc.: Journal of Armored Force Engineering Institute. Vol. 11(1997), p.54.

3. Tao Jinzhang, Na Shunsang, Yang Haixia.: Proceedings of Hebei province Steel Rolling Technology and academic convention (2007), p.20.

4. Tao Jie, Zhao Yutao, etc. : Chemical Industry Press(2007), p.6.

5. Wang Ying, Liu Xiangdong. : Research Studies on Foundry Equipment. Vol. 3 (2003), p.18.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Analysis of High-Speed Milling Surface Topography and Prediction of Wear Resistance;Materials;2022-02-24