Vacuum Brazing Porous W and Mo Using Ti-Ni-Nb Braze Alloys-Reference-Cited by-同舟云学术

Vacuum Brazing Porous W and Mo Using Ti-Ni-Nb Braze Alloys

Published:2011-11 Issue: Volume:410 Page:187-190
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Lin C.C.¹,Chen Chun¹,Shiue Ren Kae¹,Shy H.J.²,Chang C.Steve³

Affiliation:

1. National Taiwan University

2. Chung-Shan Institute of Science and Technology

3. Engineered Materials Solutions

Abstract

A novel approach of brazing porous W and Mo using three clad Ti-Ni-Nb foils has been performed in the experiment. Clad Ti-Ni-Nb filler foils are featured with low brazing temperature of below 1350°C. Both W and Mo are completely soluble with β-Ti and Nb, and the Ni addition into the braze alloy is served as a melting point depressant (MPD). Decreased brazing temperature and/or time are necessary in order to minimize infiltration of the molten braze into the porous W substrate. According to the experimental results, Ti-Ni-Nb ternary alloys are promising filler metals in low-temperature brazing porous W and Mo.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.410.187.pdf

Reference10 articles.

1. O.P. Solonina and N.M. Ulyakova: Metal Sci. Heat Treat. Vol. 15 (1973), p.310.

2. D.L. Olson, B. Mishra and D.W. Wenman: Mineral Proc. Ext. Met. Rev. Vol. 22 (2001), p.1.

3. C.H. Cadden and Jr. B.C. Odegard: J. Nucl. Mater. Vol. 283-287 (2000), p.1253.

4. Y. Hiraoka and S. Nishikawa: Inter. J. Refrac. Met. H. M. Vol. 7 (1996) p.311.

5. Y. Hiraoka: Inter. J. Refrac. Met. H. M. Vol. 11 (1992), p.303.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Joining of Refractory Metals and Refractory Metal-Based Composite Materials;Journal of Smart Processing;2015