Design of Digital Controlled Signal Generator Based on DDS and MCU-Reference-Cited by-同舟云学术

Design of Digital Controlled Signal Generator Based on DDS and MCU

Published:2012-02 Issue: Volume:468-471 Page:879-884
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Chen Yin Jun¹,Yuan Ze Huai¹

Affiliation:

1. Zhaoqing University

Abstract

Its advantage to use DDS chip is output signal frequency bigger, and precision higher, But users can't change the output signal waveforms. The MCU can produce the required arbitrary waveforms, but its program execution of the order limit the speed.So we use their Synergy to design the digital controlled signal generator. The System has the advantage of output good quality waveform, frequency of precision and stability ,and high frequency, empty, amplitude and phase is to step into the need.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.468-471.879.pdf

Reference6 articles.

1. Lygouras J. N., Tarchanidis K. N., Tsalides Ph. G., Suspended Sediment and Dye Concentration Measurements Using a Digital Techniques, Int. J. Electronics, 87, No. 1, p.107, (2000).

2. Webster J. G. Ed., Tactile Sensors for Robotics and Medicine, Wiley, New York, (1988).

3. Dally J. W., Rilley W. F., Mcconnel K.G., Instrumentation for Engineering Measurements, Wiley, New York, (1993).

4. Tarchanidis K. N., Ioannidis I. N., Kakkalis I. K. And Lygouras J. N., FLEXIMAT, an Integrated System Scanning the Bending of Any Matress., Int. Workshop on Virtual and Intelligent Measurement Systems, VIMS 2000, Annapolis, MD, USA, 29-30 April 2000, p.115, (2000).

5. Koukourlis C. S., Voulgaris N. C., A Digital Method for Sinewave Generation., Archiv fur Electrotechnik, 72, p.327, (1989).