Investigation of influence of conditions of obtaining PA6/MMT nanocomposites on their thermal properties-Reference-Cited by-同舟云学术

Investigation of influence of conditions of obtaining PA6/MMT nanocomposites on their thermal properties

Published:2022-06-01 Issue:1 Volume:5 Page:160-165
ISSN:2617-7307
Container-title:Chemistry, Technology and Application of Substances
language:
Short-container-title:CTAS

Author:

Krasinskyi V., ,Kochubei V.,Zemke V.,Dulebova L.,Ivanukh O., , , ,

Abstract

The influence of additional thermal and thermomechanical treatment of PA6/MMT nanocomposites obtained from the formic acid solution on their heat resistance and technological properties was investigated. Thermal analysis established that heating the nanocomposite to a temperature of 250 ºС and treating it on a capillary plastometer IIRT at a temperature of 230 ºС increases the degree of crystallinity and heat resistance of the samples. It is shown that additionally treated nanocomposites also have lower fluidity and significantly higher values of softening temperature.

Publisher

Lviv Polytechnic National University

Subject

General Medicine

Reference17 articles.

1. 1. Krishna, S., & Patel, C. M. (2020). Computational and experimental study of mechanical properties of Nylon 6 nanocomposites reinforced with nanomilled cellulose. Mechanics of Materials, 143, 103318. https://doi.org/10.1016/j.mechmat.2020.103318

2. 2. Ma, Y., Jin, S., Yokozeki, T., Ueda, M., Yang, Y., Elbadry, E. A., Hamada, H., & Sugahara, T. (2020). Effect of hot water on the mechanical performance of unidirectional carbon fiber-reinforced nylon 6 composites. Composites Science and Technology, 200, 108426. https://doi.org/10.1016/j.compscitech.2020.108426

3. 3. Hagihara, H., Watanabe, R., Shimada, T., Funabashi, M., Kunioka, M., & Sato, H. (2018). Degradation mechanism of carbon fiber-reinforced thermoplastics exposed to hot steam studied by chemical and structural analyses of nylon 6 matrix. Composites Part A: Applied Science and Manufacturing, 112, 126-133. https://doi.org/10.1016/j.compositesa.2018.05.034

4. 4. Yañez-Macias, R., Hernandez-Hernandez, E., Gallardo-Vega, C. A., Ledezma-Rodríguez, R., Ziolo, R. F., Mendoza-Tolentino, Y., Fernández-Tavizon, S., Avila-Orta, C. A., Garcia-Hernandez, Z., & Gonzalez-Morones, P. (2019). Covalent grafting of unfunctionalized pristine MWCNT with nylon-6 by microwave assist in-situ polymerization. Polymer, 185, 121946. https://doi.org/10.1016/j.polymer.2019.121946

5. 5. El Achaby, M., Ennajih, H., Arrakhiz, F. Z., El Kadib, A., Bouhfid, R., Essassi, E., & Qaiss, A. (2013). Modification of montmorillonite by novel geminal benzimidazolium surfactant and its use for the preparation of Polymer Organoclay nanocomposites. Composites Part B: Engineering, 51, 310-317. https://doi.org/10.1016/j.compositesb.2013.03.009