Experimental Study of a Prototype Solar Water Heater Used in Sahelian Homes

Abstract

Environmentally-friendly, low-cost energy supplies are the backbone of sustainable development. Development must not only meet current needs, but must also look to the future and consider environmental issues as a challenge. Solar power as an environmentally-friendly energy source is a promising way of reducing greenhouse gas emissions. One of the most important applications of solar energy is the production of hot water using solar water heaters. These solar water heaters, which can provide between 100 and 200 l/d of hot water over a temperature range of 40-70°C., are of the separate-element and integrated-storage types. In the Saharan environment, hot water requirements are concentrated in winter. It is therefore necessary to develop efficient systems adapted to this reality. It is then necessary to develop effective systems adapted to this reality. There is a need to propose a new design to boost the solar irradiation absorbed by the collector-storage while reducing nighttime thermal losses. For greater user-friendliness and with the aim of adapting them to the Saharan environment, it is also necessary to offer solar water heaters integrated into the building and operating mainly in the winter period. The present work represents an experimental study of a solar water heater with separate elements and a simple design, in a Burkinabe climate. This is a separate element solar water heater with a capacity of 200 liters with an aluminum collector as absorber designed at the Research Institute of Applied Sciences and Technologies (IRSAT). The water in the tank forms a loop with the sensor. In the tank, donut a copper coil of a length equal to 15m with a diameter of 16mm. They use the principle of thermosyphon (cold water pressure) to circulate and store heat and are simpler and less expensive, but can only be installed in sunny countries and have limited efficiency. During the measurement period from 11:25 a.m. to 4:05 p.m., the maximum temperature of the hot water was around 57°C at 11:45 a.m., and that of the cold water was around 27°C at 12:15 p.m.. The experimental results showed acceptable thermal performance despite the simplicity of the sensor. Finally, an improvement can easily be made whether by perfecting the thermal insulation or using selective collection surfaces.