Affiliation:
1. KARABÜK ÜNİVERSİTESİ, MÜHENDİSLİK FAKÜLTESİ
Abstract
This paper provides a 3rd order oscillator circuit utilizing CDCTA (Current Differencing Cascaded Trans conductance Amplifiers) to address issues with high power consumption and low oscillation frequency in oscillators. The suggested arrangement provides four explicit current outputs and two voltage outputs concurrently using just one CDCTA and three grounded passive capacitors. The circuit only uses 1 mW of power, has a maximum sensitivity of 0.5, and oscillates at a frequency of up to 10 MHz Additionally, both its oscillation frequency and condition may be electrically and independently adjusted. The theoretical analysis of the circuit was confirmed by the results of computer simulation using 45 nm gpdk cadence virtuoso program.
Publisher
Gazi Universitesi Fen Bilimleri Dergisi Part C: Tasarim ve Teknoloji
Reference16 articles.
1. [1] S. Haykin, M. Moher, An introduction to analog and digital communications, John Wiley & Sons, New York, 2007. www.wiley.com/college/wileyplus
2. [2] W. Bolton, Measurement and instrumentation systems, Newnes, Oxford, 1996.www. Measurement-Instrumentation-Systems-W-Bolton/dp/0750631147
3. [3] P. Prommee, K. Dejhan, “An integrable electronic-controlled quadrature sinusoidal oscillator using CMOS operational transconductance amplifier,” International Journal of Electronics, vol. 89, pp. 365-379, 2002. DOI: 10.1080/713810385
4. [4] M. Kumngern, S. Junnapiya, “Current-mode third-order quadrature oscillator using minimum elements,” in Proceedings of International Conference on Electrical Engineering and Informatics (ICEEI), Indonesia, 2011, pp. 1-4. DOI: 10.1109/ICEEI.2011.6021799
5. [5] S. Maheshwari, I. A. Khan, “Current controlled third order quadrature oscillator,” IEE proceedings, Circuit, Devices and Systems, vol. 152, pp. 605-607, 2005. DOI: 10.1049/ip-cds:20045185